I found this little Alinco DJ-S41C handheld pocket sized UHF transceiver on eBay and the auction ended for £28 including postage. The radio. DJ-S Instruction Manual. Thank you for purchasing this ALINCO FM transceiver. This instruction manual contains important safety and operating instructions. • Frequency range/DJ-S41T MHz, DJ-S41(C) mA (30mA S(c)) @V DC, RXI with the UP/DOWN keys (DJ-S41T only ).
|Published (Last):||25 August 2009|
|PDF File Size:||11.3 Mb|
|ePub File Size:||19.33 Mb|
|Price:||Free* [*Free Regsitration Required]|
Tapped during Scan, will stop it on current freq VFO or memory. Many modessome keys uses in modes are cross referenced. This unit is not FCC type-accepted for anything but ham band – Pres PTT for at komme ud. I have yet to figure out how practical it’s going to be for joining the fox-hunt chat on mobile may need a passive-re-radiator on the window like cellphone users have for MHz — no, I don’t want a new dual-band mobile!
I’ve seen passive-re-radiators for folks using pocket cellphones also mW devices in cars without installation kits; they clipped to the car window. The programming modes initiated by the F -of-key are: What a stupid little “manual”, it’s all of one sheet, with some space wasted with cyrillic and japanese translations of the half-complete quick reference chart.
WELCOME TO KBC IMPORT/EXPORT
The Interactive Diagram image cred: The unit will can send courtesy tones, possibly useful when simplex or if the repeater doesn’t but you want to. While scanning, tapping some buttons are ignored, others just stop the scan.
This modification is read times. Not terribly useful for hams, who ought to know their frequency The antenna connection is made by means of a gold-plated spring contact. It’s in a very handy location for its intended use, even thought at mW, who’m I gonna win a double with? This radio was released by Alinco around the mid ‘s likely from what I can see from the user manual I downloaded off the internet. I guess with a IC-4AT a few miles further out. View all modification in one click. Does what you expect most of the time, push it and you talk.
ALINCO DJ S41C EPUB
I’ll have to ‘brew one with a or whatever Tapped during Scan, will stop it on current freq VFO or memory. I was expecting a bit more range; I think some of our downtown repeaters must have desense problems or have their squelch too high. The rear cover can be lifted and removed easily, as there are no wires to be concerned about.
I realize there really isn’t room for a set of helicals, even forbut since I do not buy anything except used scaners cheap at a flea market that has “extended receive” expressly to avoid intermod and image problems, I was a little dissappointed to have dj-x41c fetch up on some perfect doubles between commercial and dj-s14c service UHF users. The display should show all segments and markings.
On-DOWN turns the “stand-by beep” or courtesy tone off. One of the best alknco quality HT’s ever made.
On-Scan is not documented as doing anything. On-Call toggle Lamp stays on: Repeater offsets start at 5MHz, conforming to expectations. PTT exits many of the modes. Look for a small about 1 mm green surface mount resistor actually a 0 ohm jumperlocated on the far left side of the exposed circuit board, located to the “northwest” of the speaker.
ALINCO-EAANTENNA-FOR-DJ-S41C-ECLPD K-PO – CB-Radios and Accessories Shop
On-Call toggle Lamp stays on: Setting the desired Tone or Shift value isn’t dj-e41c, you have to activate it. This may be a feature, it lets you test a change without committing to it.
Bill Ricker – n1vux amsat. Just about each F -button combo either enters programming mode or toggles a global mode. Alinco didn’t correct me, so I guess I’m right. This is used for the mandator listen-before-talk as specified in Part and ARRL good operating practices. At mW it’s using paralleled finals: Carefully remove this resistor, using a small tip soldering iron, tweezers and a steady hand. If you can’t read the fine print on the schematic, you probably don’t want to mess with surface mount anyway, ej-s41c I want to know how it works.
The Modes described under each key are cross-referenced further down.
aoinco I haven’t tried it in TONE, maybe it would let you do tones quicker? The programming modes initiated by the F -of-key are: If you can’t read the fine print on the schematic, you probably don’t want to mess with surface mount anyway, but I want to know how it works. Er ikke oplyst i den Engelske brugervejledning. On-LAMP will toggle whether the light stays turned on until you tap it off again or goes out on its own. I’ve seen passive-re-radiators for folks using pocket cellphones also mW devices in cars without installation kits; they clipped to the car window.
Pres denne knap og der er lys i displayet i 5 sek. Or use rechargeable batteries. But it fits in the vest pocket with the radio: The unit will can send courtesy tones, possibly useful when simplex or if the repeater doesn’t but you want to. Can’t you find a alino, please don’t e-mail to me.
You can tell which you’re in since the Calling channel when in use from Call shows as C in the memory channel number, rather tha c. But not bad either, compared to say my cheap wide-open scanner on the same frequencies, though, it’s reasonably intermod resistant.