Norma ASTM Standard Classification System for Specifying Plastic Materials1 by aletapia in astm. Find the most up-to-date version of ASTM D at Engineering ASTM D − Standard Classification System for Specifying Plastic Materials. R&B Inc. 편집자 주. ▫ 본 한글 본은 R&B Inc. 내부재료로 일부 용어는 표준용어.
|Published (Last):||9 April 2017|
|PDF File Size:||17.64 Mb|
|ePub File Size:||7.57 Mb|
|Price:||Free* [*Free Regsitration Required]|
A basic property table aatm provide property values. This standard is not included in any packages. Added ISO and -2 as references for second letter M. ICS Number Code It is not intended for the selection of materials. Note 2—When using this classification system the two-letter, three-digit suffix system applies. Need more than one copy?
ASTM D4000 – 16
When the requirements for a material are included in this standard, the following sections are applicable. The generic family is identi?
Cell Limits 4 40 2 Originally published as D — If desired, the referenced standards may be used since a similar system is used in each document. This standard is also available to be included in Standards Subscriptions. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Aastm a material is used to fabricate a part where the requirements are too specific for a broad material call-out, it is advisable for the user to consult the supplier to secure a call-out of the properties to suit d40000 actual conditions to which the part is to be subjected.
The cell tables that may be used for each generic family are listed aastm Table 1. Please first verify your email before subscribing to alerts.
If the document is revised or amended, you will be notified by email. These characteristics will be spelled out in detail and identi? It is not intended for the selection of materials. As the voice of the U. Standards Subsctiption may be the perfect solution.
ASTM D – 16 – Standard Classification System for Specifying Plastic Materials
This standard is also available to be included in Standards Subscriptions. D — 00a: The classification system serves many of the needs of industries using plastic materials.
Please first verify your email before subscribing to d0400. If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below.
These tables are found in the standards aztm in Table 1. You may delete a document from atm Alert Profile at any time. These letters represent the standard abbreviations for plastics in accordance with Terminology D When the existing cell table does not adequately describe the material, then suffixes may be used in place of a cell table designation.
Changed second letter M from tensile modulus to tensile stress. NOTE 3—When a material is used to fabricate a part where the requirements are too speci? The following summarizes the line call-out and the entire system as detailed in this standard. Additional symbols will be added to this table as required.
Standards Subsctiption may be the perfect solution. The standard is subject sstm revision as the need requires; therefore, the latest revision should always be used. Note 3—When a material is used to fabricate a part where the requirements are too specific for a broad material callout, it is advisable for the user to consult the supplier to secure callout of the properties to suit the actual conditions to which the part is to be subjected.
ASTM International – Standard References for ASTM D – 16
The suffixes that may be used are listed in Table 3. Thus, a letter designation G for glass-reinforced and 33 for percent of reinforcement, G33, speci? The letter designation applicable is followed by a four-digit number indicating group, class, and grade.