ASTM D Standard Test Methods for In-Place Density and Water Content of Soil and Soil-Aggregate by Nuclear Methods (Shallow Depth). depth, etc.) Verify proper rebar sizes and placements. Verify proper reinforcing overlaps. Verify proper clearance and that chairs are. ASTM D Uploaded by Xavior. Standard Test Method for In-Place Density and Water Content of Soil and Soil- Aggregate by Nuclear Methods (Shallow.

Author: Nacage Zulkikinos
Country: Monaco
Language: English (Spanish)
Genre: Photos
Published (Last): 19 May 2009
Pages: 269
PDF File Size: 9.1 Mb
ePub File Size: 8.93 Mb
ISBN: 990-5-37255-542-4
Downloads: 28470
Price: Free* [*Free Regsitration Required]
Uploader: Kigakree

When divided by ast, density of water and then multiplied bythe water mass per unit volume is equivalent to the volumetric water content.

This test method describes the procedures for measuring in-place density and moisture of soil and soil-aggregate by use of nuclear equipment. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.

Reliable results depend on many factors; Practice D provides a means of evaluating some of those factors. Most gauges display this value directly.

Active Risk Management

The values in inch-pound units ft — lb units are provided for information only. The dry density of the test sample is obtained by v6938 the water mass per unit volume from the test sample wet density Section Most gauges display this value directly. The water mass per unit volume is determined by the thermalizing or slowing of fast neutrons by hydrogen, a component of water.


Link to Active This link will always route to the current Active version of the standard. The density of the test sample in mass per unit volume is calculated by comparing the detected rate of gamma radiation with previously established calibration data.

The nondestructive nature allows repetitive measurements at a single test location and statistical analysis of the results.

Request Quote Client Login. In addition, they ast, representative of the significant digits that should generally be retained. For more information, contact: Soil testing Back to Results Print.

ASTM D Standard

The total or wet density of soil and soil-aggregate is measured by the attenuation of gamma radiation where, in direct transmission, the aatm is placed at a known depth up to mm 12 in. Measurements for water moisture content are taken at astn surface in backscatter mode regardless of the mode being used for density.

For Individuals with needing special assistance for disabilities or limited English proficiency Please contact our Title VI specialist at Soil testing Field Services: The quality of the result produced by this standard test method is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used.


It is the responsibility of the user of this asttm to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Users of this standard are cautioned that compliance with Practice D does not in itself ensure reliable results.

Historical Version s – view previous versions of standard. The neutron axtm and the thermal neutron detector are both located at the surface of the d69338 being tested.

Measurements for water moisture content are taken at the surface in backscatter mode regardless of the mode being used for density. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

This places the gamma and neutron sources and the detectors in the same plane. The water content most prevalent in engineering and construction activities is known as the gravimetric water content, w, and is the ratio of the mass of the water in pore spaces to the total mass of solids, expressed as a percentage. Sstm direct transmission is the preferred method.

Author: admin