COUSSINETS SKF PDF

Comme pour les coussinets et les bandes composites, SKF fabrique de série des rondelles de butée composites à partir de matériaux composites PTFE et POM. For additional information about the meaning and limitations of the product data, refer to SH bushings. Imprimer cette page; Partager. d, 35, mm. D, 60, mm. D1, 68, mm. L, 37, mm. L1, 49, mm. B, , mm. Calculation data. Max. torque, Mv, , N·m. Max. axial load, Pa, 41, kN. Mounting.

Author: Aragami Vishakar
Country: Iraq
Language: English (Spanish)
Genre: Love
Published (Last): 17 March 2011
Pages: 229
PDF File Size: 15.61 Mb
ePub File Size: 11.20 Mb
ISBN: 127-5-89156-436-6
Downloads: 14977
Price: Free* [*Free Regsitration Required]
Uploader: Yozilkree

Coussinets à enroulement filamentaire SKF

Care should always be taken when mounting FW bushings not to damage the coussinetd layer or side faces. Once all the components have been cleaned and checked, the bushing is ready to be installed. To install bushings, with or without a flange, SKF recommends using a mounting dolly particularly for composite fig.

The position of the lubrication groove of solid bronze bushings depends on whether it is an oscillating or rotating or movement and, for the latter, whether oil or grease lubrication is applied fig.

  1756 RMC1 PDF

Then drive the bushing into place with a mechanical or hydraulic press or by tapping the dolly lightly with a hammer. For larger bushings, SKF recommends using a mounting ring fig.

Otherwise when the bushing comes in contact with absorbent material it may wick the oil away very quickly. Mounting Skill and care in mounting are prerequisites for long bearing service life.

Sufficient cooling fluid should be applied as well to avoid excessive temperatures, as they can destroy the cosusinets.

To facilitate the mounting of small bushings, apply a light coating of oil or grease to the housing bore. When applying an adhesive, care should be taken so that no adhesive reaches the sliding surface. If composite plain bearings, for example strips, are to be located in a housing cokssinets an adhesive, the adhesive should be suitable for the expected operating temperature and should have suitable expansion, aging resistance, strength and curing properties.

Joints à frottement mécanique, coussinets SH

SKF also recommends, particularly for larger bushings where more force is required that they be cooled before mounting. In addition, cleanliness, and understanding the causes of premature bearing failure doussinets help too. SKF sintered bronze bushings are impregnated with a lubricant and.

  KURINJI MALAR NOVEL PDF

Check also the shaft for sharp edges, burrs or surface defects, which could damage the sliding surface of the bushings. If no operational experience is available, SKF recommends contacting an adhesive skff for advice.

To facilitate mounting FW busings, the bushing may be split lengthwise into two halves by using a diamond coated skff wheel. When mounting, thrust washers should be positioned so that the steel backing abuts the housing wall.

Modèles et variantes

Imprimer cette page Partager Partager cette page. Check that the counter surface shaft seat and other components such as the housing are clean, deburred and that they do not contain any abrasive particles. To do this, place an O-ring on the dolly to keep the bushing in position.

Author: admin