If you just had a baby, are expecting, or are taking care of a young infant it’s important to create a safe sleep environment for your baby. Because babies spend. Federal law requires that bunk beds comply with the bunk bed standard and with additional requirements, including those of the Consumer Product Safety. Product Safety Commission (CPSC) handbook offers guidelines for pool . This section explains the CPSC swimming pool barrier .. Web site:
|Published (Last):||17 January 2007|
|PDF File Size:||13.72 Mb|
|ePub File Size:||4.55 Mb|
|Price:||Free* [*Free Regsitration Required]|
When the thickest mattress and mattress foundation recommended by the gpv are used, the top of each end of the upper bunk must extend at least 5 inches above the top of the mattress, and that 5-inch margin of safety must extend at least half of the distance between the corner posts of each end.
The ends of a bunk bed are the upright parts at the head and foot of the bed to which you attach the side rails. Are there any additional requirements for bunk beds? What is the goc of the bunk bed rule? Bunk beds that are designed or intended for children 12 years of age or younger are subject to surface coating requirements, lead and phthalate content limits, testing and certification, and tracking label requirements.
No opening in either end of the upper bunk that is above the mattress foundation can let the wedge block pass through freely. Are there any standards that apply to bunk beds? Constant and active supervision should be maintained when any child is in or around water 1.
Guardrails must be attached to the bunk bed with fasteners that must be released before the rails can be removed, OR the rail or fastener must be designed to move in two or more different directions, one after the other, to release them. Psssa can I find additional information?
A bunk bed is a bed with the bottom of its mattress foundation more than 30 inches above the floor. Linking to this external site does not constitute an endorsement of the site or the information it contains by CPSC or any of its employees.
CFOC Standards Database | National Resource Center
Children’s bunk beds may not be painted with paint that contains more than 0. No opening in the headboard or footboard of the lower bunk below the mattress foundation of the upper bunk and above the mattress foundation of the lower bunk shall permit the wedge block to pass through freely – UNLESS the opening also allows a rigid 9-inch sphere to pass through it freely.
Drowning is the second leading cause of unintentional injury-related death for children ages one to fourteen 5. Similarly, Section 14 a 5 of the CPSA requires a children’s product and its packaging to have a tracking label or other distinguishing permanent mark. A guardrail on the side of the bed away from the wall does not have to run continuously from end to end of the bed, BUT the distance between either end of the guardrail and the end of the bed nearest to it cannot be greater than 15 inches.
Third party testing is not required for these requirements. Lower bunks with mattress foundations that are 30 inches or less from the floor do not have to have guardrails. The suction cups, however, may release suddenly, allowing the bath ring and infant to tip over. Inapproximately 1, children under the age of twenty in the U. What does the bunk bed rule require? Children’s bunk beds, like all products that are designed or intended primarily for children 12 years of age or younger, must be tested by an accredited and CPSC-accepted third party conformity assessment body for compliance with applicable children’s product safety rules.
The link you selected is for a destination outside of the Federal Government. The need for constant supervision is of particular concern in dealing with very young children and children with significant motor dysfunction or developmental delays.
Office of Compliance for specific enforcement inquires: What is a bunk bed? Click Ok ccpsc you wish to continue to the website; otherwise, click Cancel to return to our site.
This communication has not been reviewed or approved by the Commission, and does not necessarily represent their views. Because of the detail involved in performing the test, the test procedure is not summarized here. If the sphere passes through freely, test the opening for neck entrapment. S died from drowning Bunk beds for children may not have sharp points or edges.
Chapter 2: Program Activities for Healthy Development
Bunk bed requirements call for a specific warning label AND a label or marking that provides the name and address of the manufacturer or importer, model number, and month and year of manufacture. What are the additional requirements for bunk beds required by the Consumer Product Safety Improvement Act of ?
Thirty children under five years of age died from drowning in buckets, pails, and containers from While swimming pools pose the greatest risk for toddlers, about one-quarter of drowning among toddlers are in freshwater sites, such as ponds or lakes. Consumer Product Safety Commission: Of all buckets, the five-gallon size presents the greatest hazard to young children because of its tall straight sides and its weight with even just a small amount of liquid. When testing spaces between the guardrail and upper mattress foundation, pull the wedge gradually, and sustain a force of 33 foot-pounds for 1 minute.
The tracking label, to the extent practical, requires basic information, including the source of the product, date of manufacture, and cohort information, such as a batch or run number.
Any opening in the headboard or footboard of the lower bunk below the mattress foundation of the upper bunk tested with the wedge block must also be tested for the risk of neck entrapment if the opening lets the 9-inch sphere pass though freely.
With no mattress on the bed, use the wedge block to probe spaces between the guardrail and upper bunk mattress foundation and openings in the upper and lower bunk ends.