HUAWEI DBS3900 WIMAX PDF

Huawei in stock for sale [email protected] PN/Model Qty Product Description MHRD1 UG01MHRD1 2 MHRD UMG 34 MVPD UG01MVPD1. DBS WiMAX Product DescriptionVR Issue Date V and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd. All other. DBS WiMAX VR Product Description V3[1] – Download as PDF or by any means without prior written consent of Huawei Technologies Co., Ltd.

Author: Fenrilmaran Grolar
Country: Kenya
Language: English (Spanish)
Genre: Environment
Published (Last): 7 September 2004
Pages: 374
PDF File Size: 9.36 Mb
ePub File Size: 13.65 Mb
ISBN: 934-4-53263-176-6
Downloads: 81371
Price: Free* [*Free Regsitration Required]
Uploader: Tygokus

The MS obtains the information of neighboring BSs through scanning. Paging Offset Paging frame offset. This process is outer-loop power control. The idle mode feature prolongs the service activation time. Closed-loop power control is precise.

Procedure l Activate MS-initiated handovers.

DBS3900 Distributed Base Stations

In optimum conditions, two receiving signals may be combined into one signal with the power doubled. If the xbs3900 of the bit is 0, the handover feature is not supported.

Space-time Space-time coding STC is a signal coding technology that can be used coding to obtain enhanced data transmission rates. If the value of the bit is 1, the handover feature is supported. The largest variation that can be tolerated is the value of Tolerated Dbs3900.

The drawback to this networking mode is reduced sector throughput because each sector uses only one-third of the sub-channels. The optimization of the process expedites network reentry and reduces the handover delay.

Therefore, the delay in the same service wiimax varies. On the downlink, the BS limits the rate at the entry of the network. Featuring eLTE mobile broadband access, modular design, simple installation, flexible deployment, and low power consumption. Network Model Figure shows the network model of the idle mode feature. In areas where the signal quality is good, all the sub-carriers are used to guarantee efficient use of frequency spectrum resources. In this mode, co-channel interference does not occur between BTSs.

  CLUNIS REPORT PDF

Huawei DBS WiMAX Archives – HUAWEI Mobile Core Network, OSN-Optical, Wireless Reseller

Downlink CDD CDD is implemented through the transmission of data duplicate with different delays through different antennas. AMC provides rough and slow adaptive control within a large dynamic range. QoS offers operators with effective control over the use of network resources.

This process is known as a handover, which is a major function enabling mobility management in wireless communications. If you need to get information about your project, please submit your information and we will contact you within one working day. Figure Transmit matrix of Matrix A In the scenario of Matrix A transmission, the recommended wimsx of receive antennas at the receiver side is two or more.

It supports open loop and closed loop power control to minimize fading effects and interference, thus improving transmission quality. The QoS parameters of the rtPS are as follows: The value of this parameter indicates the maximum size simax buffer that a sub-burst can occupy.

The user plans OM transmission parameters dbs3900 each BS on the network according to the actual situations of the bearer network and the details of network planning. When the uplink signal is poor, the MCS is lowered or the transmit power of the MS is raised to ensure correct signal demodulation on the uplink. Specifications System peak throughput: In uplink CSM, the terminals of hauwei transmit-only antennas are fixed to the same time or frequency resources.

  1769 L31 PDF

Convention Description Boldface Buttons, menus, parameters, tabs, window, and dialog titles are in boldface. Hard handover A hard handover is a handover in which the terminal is disconnected from the source cell before a connection is established between the terminal and the target cell.

UGS — Transmission policy: The IP path is only a concept and management entity on the control plane, and it is invisible to service flows on the user plane. When the system load becomes normal, the system congestion is automatically and quickly cleared. Yes, if you don’t know which product is good, let us know your detail requirements, our engineers will recommend you a proper device according to your target.

Figure shows principle of CDD. Also, they might go to your country to help with technical problems if necessary.

DBS WiMAX Feature Configuration Guide | Panku Singh –

There is a process of storing, processing, and forwarding. Prefabricated Modular Data Centers. Therefore, engineers need to use MML commands on the M to manually configure the OML information of the network element for future use and maintenance. Click here to visit partner zone to check enquiry status, manage orders, get support, or learn more about Huawei partners.

With the CDD technology, the power gain can be obtained from multi-antenna transmission. China pc ieee China ieee China cable ieee.

HARQ can be enabled for the service flow only when the previous two thresholds are smaller than those thresholds in the QoS parameters set for the MS.

Author: admin